Section 16
Revocation of permit
of Rubber Industry Board Licensing And Permits Regulations 2015
(1)
The Panel may require a permit holder to provide explanation as to why his or its permit should not be revoked if the Panel is satisfied that -
(a)
any conditions imposed on the permit has not been complied with or has been contravened;
(b)
the grant of the permit was induced by a false representation of facts by or on behalf of the permit holder;
(c)
the permit has been used or is intended to be used for an unlawful purpose;
(d)
the original purpose for which the permit was issued no longer exists;
12
(e)
the permit holder has contravened or has failed to comply with any provisions of the Enactment, any regulations made under the
Enactment or any other written law;
(f)
the permit holder has ceased to carry on the activity for which the permit was issued;
(g)
the permit holder has tarnished the good image of the rubber industry;
(h)
the decision of the Panel or any enforcement officer has not been complied with; or
(i)
there exists any other circumstances to warrant such action.
(2)
The Panel may revoke the permit if the permit holder fails to provide the explanation as required under subregulation (1)